Clutch-by-wire. CBW linearisation (characteristics).

It is possible to apply clutch-by-wire linearisation with HTG tuning Gearbox Control Unit. That table adjusts feel of clutch-by-wire pedal response (analog based proportional sensor). If the input is a digital input (switch for example) that table has not much use ut can be used to limit maximal points of the switch. To enable clutch-by-wire [...]

By |2020-10-19T17:30:22+00:00October 19th, 2020||Comments Off on Clutch-by-wire. CBW linearisation (characteristics).

Clutch-by-wire. How to connect clutch input to GCU?

CBW functionality can be triggered with any kind of input - analog, digital, CAN message. Assigning analog signal or proportional CAN message gives You ability to control clutch proportionally. Using digital (1-0) inputs or just switches will result in instant transitions. Choose Your triggering method based on application needs. Switches or potentiometers - feed them [...]

By |2020-05-19T23:51:12+00:00May 19th, 2020|, |Comments Off on Clutch-by-wire. How to connect clutch input to GCU?

Clutch-by-wire. Can I make clutch kick using GCU?

Clutch-by-wire or virtual clutch as some may call it can be used with many transmissions running HTG tuning Gearbox Control Unit. We support CBW functionality with any dual clutch transmission and also with various hydraulic ones like 8hp70, 6hp series. Take-up (starting of drive) remains unaffected - GCU will perform clutch control, use of clutch [...]

By |2020-05-19T23:31:21+00:00May 19th, 2020||Comments Off on Clutch-by-wire. Can I make clutch kick using GCU?

Go to Top