1.1.4 HTG firmware

Overview #

Update 1.1.4 is last stop before 2.0 release introducing HTG IO CAN to HTG SUITE officially. This update adds couple new presets and adresses reported bugs.

REQUIRED STEPS: as always – install latest HTG SUITE, connect to device(Shift + C), download config from the device (Shift + D), send to the device (Shift + S). This procedure updates config to latest version. Now go to Device tab -> LOADER and upload latest firmware-1.1.4.

GENERAL changes: #

• Changed SUITE tab names in preparation to IO CAN deployment
• Changed datalogger channel names
• Added CAN bus presets:
  • Bosch MED 7.1.1
  • Bosch MED 9.1
  • Siemens MSD 81
  • Siemens Simos 18.1
• Added datalogger channel search option
• Added datalogger channel add hotkey
  • Ctrl + D adds datalogger plot
  • Left click selects active plot and
  • X and V open channel search for left and right side respectively
  • Type in phrase, use arrows to highlight desired filtered channel and hit ENTER twice
• Added CAN dump list sorting (HEX asc.)
• Added IO config CAN bus list sorting (HEX asc.)
• Added live tuning of:
  • Global:
    • IN – OUT linearisation scaling
    • Saturation switch
    • Verification time
    • Cooldown time
  • DIG_in:
    • Invert switch
  • AN_switch:
    • Pull-up value
    • Pull-down value
    • Tolerance value
  • CAN_bus:
    • Offset value
    • Length value
• Fixed General settings widnow scaling for multi screen setups
• Fixed status bar dual clutch pressure value freeze when clutch is off
• Fixed CAN bus presets overwriting manually assigned objects

HTG GCU changes: #

Dual clutches: #

• Fixed dynamic adaptation saving incorrectly
• Improved overrun clutch pressure clamping

ZF 8HP: #

• Improved control of 3rd generation 8HP