NCPCB GS7 DQ500 installation guide v1 v2

How to properly install NoiseCancellingPCB for GS7 and DQ500 gen.2

Connections:

Note 1: On the v0.1 board signals A3,A4,B3 are marked as F1,2,3.

Note 2: DQ500 gen2 (Bosch) require only A3 and A4 connection, unlike GS7 DCT

Installation process:

1. Strip the selected wire in the harness (try to not cut the wire apart). Solder apiece of wire to pcb and thread through the hole:
2. 
   
3. Wind short wire around stripped fragment and solder them together:
4. 
   
5. Cover bare wire with heat shrink tube:
6. 
   
7. It is mandatory to select correct gearbox version in “GENERAL SETTINGS”. Templates are different while using NCPCB, so make sure to select correct one, as presented on photo below:
8.